The material is isostatically pressed to allow the milling performance equal to 1200 mpa. Nevertheless, being the most tender material, clamping the ring nut of “cialda”, without squeezing it too hard, to avoid chipping the restraining step is advised. On the matter of milling strategies, you can freely use the ones for the 1200 mpa. The material is considered similar to lithium disilicate, as they share similar characteristics. It is suitable for singular crowns and bridges with maximum 3 elements with a intermediate layer in the front area. Pay strict attention while increasing the bonds among the united elements as much as possible. For the frame work of the borders, do not go below 0.2 mm